Home
Ec-SimEE CALCULATORS
Interactive Circuit Design & Direct SPICE Export

Op-Amp Slew Rate & Full-Power Bandwidth Calculator

Solve for the highest frequency a sine of a given amplitude passes undistorted, or the slew rate or amplitude that allows.

43 • OP-AMPS

Interactive Slew Rate & FPBW Solver

Type values into any fields (using standard engineering suffixes like m, u, n, k, M) and leave the remaining field empty to solve for it.

Circuit Parameters

V/µs
V
Solve Target
Hz
Interactive Schematic Preview — Click any reference badge to focus its input field
inputabove fFPBWSR 0.5 V/µsVp 5 VfFPBW 15.92 kHz
Max Amplitude at 20 kHz
3.979 V
Peak, for full audio bandwidth
SR Needed at 20 kHz
0.628 V/µs
For 5 V peak
Large-Step Slewing Time
16 µs
10–90 % of a 2·Vp step at SR
Rule
Keep f ≤ fFPBW
Above it a sine turns into a triangle: SR, not GBW, limits large signals
FORMULAS & THEORY

Slew Rate & FPBW Equations & Design Guidelines

Core transfer equation: fFPBW = SR / (2π · Vp)

1. 1. Slew Rate Limits Large Signals

A sine V = Vp·sin(2πft) changes fastest at its zero crossings, at 2πf·Vp. The op-amp output cannot move faster than its slew rate:

  • Full-power bandwidth: fFPBW = SR / (2π · Vp)
  • Units: SR in V/µs is ×10⁶ V/s

2. 2. Simulating It

Simulate drives a slew-limited follower at exactly fFPBW: the output just keeps up. Raise the frequency in the editor to see it turn triangular.

  • GBW vs SR: GBW sets the small-signal bandwidth; SR the large-signal one. Check both.
WORKED EXAMPLE & PRACTICE

Using the Slew Rate & FPBW Calculator in a Real Design

An op-amp’s output cannot change faster than its slew rate. A sine wave’s steepest slope is 2π·f·Vp, so for any output amplitude there is a highest frequency the amplifier can reproduce without distortion: the full-power bandwidth. It is separate from, and often much lower than, the small-signal bandwidth.

Worked example: A 13 V/µs op-amp at 10 V peak

Slew rate 13 V/µs (typical of a JFET-input audio op-amp), output amplitude 10 V peak.

  1. fFPBW = SR / (2π × Vp) = 13 × 10⁶ V/s / (2π × 10 V).
  2. = 207 kHz.
  3. Check: a 10 V peak sine at 207 kHz has a maximum slope of 2π × 207 kHz × 10 V = 13 V/µs, exactly the slew rate.

What it means: The output can swing ±10 V undistorted up to about 207 kHz. A 0.5 V/µs general-purpose part manages only 8 kHz at the same amplitude.

Common mistakes

  • A Bode plot will not show it. Slew limiting is a large-signal effect. A frequency-response measurement at small amplitude, or an AC simulation, looks perfect. Test with a full-amplitude transient.
  • It distorts, it does not attenuate. A slew-limited sine becomes a triangle. In audio that appears as harsh high-order distortion on loud high-frequency content.
  • Leave margin. Distortion rises well before the limit is reached. Keep the required slope below a third to a fifth of the slew rate.