Interactive Buck Input Capacitor Solver
Type values into any fields (using standard engineering suffixes like m, u, n, k, M) and leave the remaining field empty to solve for it.
Circuit Parameters
Buck Input Capacitor Equations & Design Guidelines
Core transfer equation: ΔVin = Iout · D · (1 − D) / (fsw · Cin) + Iout · ESR, D = Vout / Vin
1. 1. Pulsed Input Current
A buck draws Iout from its input only while the switch is on. The input capacitor supplies these pulses and is recharged while the switch is off:
- Ripple: ΔVin = Iout · D · (1 − D) / (fsw · Cin) + Iout · ESR
- RMS current: Icin,rms = Iout · √(D · (1 − D)), largest (Iout/2) at D = 50 %
2. 2. Layout Matters
The input capacitor closes the hot loop with the switch and diode. Its connection inductance causes the switch-node ringing:
- Placement: Put a small ceramic right at the switch and the ground return of the diode or low-side FET.
- Simulation: Simulate feeds the stage through 1 Ω, so the ripple you see on V(VIN) comes from Cin.
Using the Buck Input Capacitor Calculator in a Real Design
A buck converter draws its input current in rectangular pulses. The input capacitor supplies those pulses so that the source and its wiring do not have to, and it carries a large ripple current as a result. Sizing it means checking both the ripple voltage it allows and the RMS current it must survive.
Worked example: 12 V to 5 V at 2 A, 500 kHz
10 µF of effective input capacitance with 5 mΩ ESR.
- D = 5 / 12 = 0.417, so D × (1 − D) = 0.243.
- Capacitive ripple = 2 A × 0.243 / (500 kHz × 10 µF) = 97 mV.
- ESR ripple = 2 A × 5 mΩ = 10 mV. Total ≈ 107 mV.
What it means: About 107 mV of input ripple. The capacitor’s RMS current is 2 A × √0.243 = 0.99 A, which its rating must cover.
Common mistakes
- Ripple current rating. The RMS current, not the capacitance, usually decides the part. It peaks at 50% duty, where it reaches half the output current.
- Placement. The loop formed by the input capacitor and the two switches carries the fastest current edges in the converter. Every millimetre of that loop adds overshoot and emissions. Place the capacitor first.
- Ringing with a long supply cable. Low-ESR ceramics and the inductance of a long input cable form a high-Q resonant circuit. Plugging in a live supply can ring to nearly twice the supply voltage. Add an electrolytic capacitor in parallel for damping.